Cabin Crusier- Equipment and specifications
100 Hull Construction
- Hi-gloss Aqua guard gelcoat finish.

- Protective vinylester tie layer for hull
- Resin infused GRP composite hull
- Female moulded composite GRP deck
- Anti- skid walking surfaces
- Forward settee with storage lockers
- Aft settee with storage lockers
- GRP engine box with sound insulation lining
- 4 X S/S cleats & 4 X S/S
- Stainless steel bow roller
- Self draining anchor locker
- Rubbing sponson
- Burmese Teak cockpit sole
- Battle flag pole
- Trailer hitch point
- 2X sacrificial anodes
200 Propulsion
- Water cooled 29hp Yanmar 3 cylinder Diesel engine
- 1’ S/S shaft
- PSS stern Gland,
- 3 blade bronze prop,
- Polyflex shaft coupling
- Inner and outer shaft bearings
- Wet exhaust system with muffler, through hull sea cock with water strainer
300 Electrical systems
- Yanmar type B Instrument panel with key start/stop, rev counter hour meter, warning lights for oil, water, battery
- Yanmar 12V/ 80 amp alternator
- Dash mounted fuel tank level indicator

- 1 X Marine battery with isolator switch
- Battery box
- Battery tray
- Battery isolator switch
500 Auxiliary systems
Galley
- FRP Compartment with provision for stove and/or insulated built-in ice box with drain located on port side of cabin
Hatches and Windows
- Glass laminated windows are tinted
- Large Hatch for fwd cabin allowing access to foredeck and anchor well.
- Small ventilation hatch located in wheel house
Steering and rudder
- Foil shaped female moulded GRP rudder blade
- S/S rudder stock with machined nylon bearings and GRP rudder tube
- Cast bronze shoe fitting to take S/S rudder shaft at built heel
- Stainless steel 13” steering wheel with cables

- Teleflex steering system
- Single lever engine control
Blackwater system
- Supplied Porta Potti with adequate provision for storage
Bildge system
- 1x Automatic electric bildge pump with float switch
- 1x Manual bildge pump located in cockpit sette lounge (port side).
Fuel Oil system
- External fuel filter
- Plumbed polyethylene 70lt fuel tank c/w
- Ball Valve shut off cock.17. Tank breather with surge protector18. Fuel/water separator19. Engine fuel return20. Deck filler black nylon 38mm
600 Outfit and Furnishing
Hardware
- 5 X s/s cleats X 4 X s/s fairleads
- Stainless steel bow roller
- Trailer hitch point
- 4 X cockpit rod holders
Anchoring and mooring
- Foredeck self draining anchor locker c/w ball valve stop cock
Windows, hatches & Lockers
- 2 x fwd sette lockers
- 2 x cabin side windows
- 1 x Self draining (large) locker hatch in aft settee
- 1 X access hatch in fwd settee
Insulation
-
Triple layer sound guard insulation for engine box.
Additional equipment
Navigation package
- 6- way splashproof instrument switch panel (fused)
- Navigation lights
- 4 X LED Cockpit lights

- LED Cabin light
- Stern Light
- Anchor Light
- 12V Auxiliary power point
- Electric windscreen wiper
Entertainment Package
- GR100 AM/FM radio with VHF receiver flush mounted in dash
- 600mm AM/FM antenna
- 2 X GME water resistant speakers flush mounted in fwd & aft sette
Swim Platform
- Transom mounted GRP swim Platform with non-skid surface
- 2 X Fabricated 316 stainless steel grab rails
Timber trim Package
- Hand crafted teak wheel house – High gloss clear coat polyurethane finish
- Laminated teak transom – High gloss clear coat polyurethane finish
- Laid teak deck
- Teak engine box cover
- Paulonia Internal ceiling (timber cabin linning)
GPS/ Fishing Package
- Humminbird GPS/fish finder combo mounted in dash includes “in hull” transducer.
Cockpit Bimini
- Custom fabricated 316 stainless steel frame

- Custom fitted Sunbrella acrylic breathable fabric sun cover.
Upholstery
- Aft settee Cockpit cushions
- Fwd V berth sette cushion
- 2 X extra large Sunbrella fabric boat fenders
- Sunbrella Cabin & cockpit storm cover
Stainless steel fabrication
- Custom 316 fabricated bow rail ( pushpit)
Equipment and specifications for Center Console
Trailable Motor Launch

100 Hull Construction
- Hi-gloss Aqua guard gelcoat.
- Protective vinylester tie layer for hull
- Hand laminated GRP composite hull (Balsa core above waterline)
- Hand laminated female moulded composite GRP deck with Balsa core
- Hand Laminated GRP engine Bearers, longitudinal stiffeners & transverse floor grid
- GRP Cockpit sole
- Non- skid walking surfaces
- Forward settee with storage lockers X 2
- Aft settee with storage lockers X 1

- GRP balsa cored engine box
- GRP Balsa cored center console
- GRP balsa cored foot well panel for center console c/w removable engine access panel
- Self draining anchor locker
- I con Plastics co extruded gunwhale rubbing strip.
200 Propulsion
- Yanmar 3YM30 F/W cooled 3 cylinder marine Diesel engine, maximum 29 HP @ 3600 RPM
- 1” S/S shaft
- Packless shaft seal
- 3 blade bronze prop
- Polyflex shaft seal coupling
- GRP stern tube with inner and outer bronze bearings
- Morse Single lever engine control and with Teleflex throttle and gear shift cables
- Wet exhaust system with waterlock muffler
- Engine cooling system, S/S thru hull scoop strainer with S/S ball valve sea cock and cooling water filter.
300 Electrical
- Yanmar Type B instrument panel with key start/stop, rev counter, hour meter, warning lights for oil, water and battery
- Yanmar 12V/80 AMP Alternator
- Dash mounted fuel tank level indicator
- Seamaster ‘ Gold’ Supercharge extra heavy duty maintenance free Marine battery 720Amps Cold Cranking
- Battery tray
- Battery isolator switch
500 Auxiliary systems
Ventilation
- 4x plastic louver vents mounted in fwd & aft sette

Bilge system
- Whale Compac 50 manual bilge pump 43L/min
- Rule 500 electric bilge pump with Sure Bail automatic float switch
Fuel oil system
- 75 litre Polyethylene diesel fuel tank c/w sump & drain cock.
- Delphi “CAV” fuel filter
- Plumbed tank breather with surge protector
- Engine fuel return
- Ball valve fuel shut off cock
- Deck filler black nylon 38mm
Steering and rudder
- 13” 3 spoke Stainless steel steering wheel with swivel knob
- Teleflex quick connect steering system
- Foil shaped GRP rudder blade
- S/S rudder stock
- GRP rudder tube with machined nylon bearings
- Cast bronze heel fitting
600 Outfit and FurnishingHardware
- 4 S/S cleats & 4 X S/S fairleads

- Stainless steel bow roller
- Trailer hitch point
- Flagstaff bracket
- 4 X cockpit rod holders
Anchoring and Mooring
- Foredeck Self draining anchor locker c/w ball valve stop cock
Windows, Hatches & lockers
- Curved and tinted console windshield with aluminum frame
- 2 X Self draining locker hatches in fwd settee
- 1 X self draining locker hatch in aft settee
- 1 X access hatch in fwd settee
Insulation
- Triple layer sound guard insulation for console and engine box
Optional extras
Timber Trim Package
- Laminated Australian hard wood sponson with 316 stainless steel rubbing strip
- Varnished teak fiddle rail on center console
- Teak decking cockpit sole c/w 2X access hatches
- Hardwood Sponsons finished with 6 coats of Bristol polyurethane varnish
- Console fiddle finished with 6 coats of Bristol Polyurethane varnish

Helmsman seat
- 1. GRP double person sliding seat
- 2. Dual compartment under seat insulated ice box/ fish tank.
- 3. Reversible seat backrest Stainless steel frame and slated teak trim.
Hard top
- Composite GRP hard top
- Fabricated 316 Stainless steel support structure
- Satin finished internal head lining
Swim Platform
- Transom Mounted GRP swim platform with Non skid surface
- Fabricated stainless steel grab rails
Navigation Package
- 6 -way splashproof instrument switch panel (fused)
- Navigation lights
- LED Cabin light
- 4 X LED Cockpit lights
- Stern light
- Anchor light
- 12V Auxiliary power point
Entertainment Package
- GR100 AM/FM radio with VHF receiver flush mounted in Console dash
- 600mm AM/FM antenna
- 2 X 6” GME water resistant speakers flush mounted in fwd and aft settee
GPS/ Fishing Package
- Humminbird GPS/ Fish finder mounted in dash with “in hull” transducer.

